Adhesive 290 Wallpaper

Adhesive 290 Wallpaper

Fiona Adhesive is an aqueous adhesive for hanging wall coverings.

Product Description

Ready-mixed, transparent, reinforced adhesive. For hanging non-woven wallpapers where the adhesive is applied to the wall.
  • Wallpaper adhesive, non-woven
  • Easy to apply
  • Can be sprayed on


Indoors in a dry room for hanging non-woven wallpaper.
On concrete, lightweight concrete, plaster, gypsum board, fibreglass, wood-fibre boards, veneer sheets, chipboard and sandblasted substrates.


Must be clean, dry, firm and suitable for substrate treatment.


Remove loose material and paint by cleaning and sanding.
Remove dirt, grime, grease and chalking materials by cleaning.
Water-soluble discolouration, nicotine and soot are cleaned and treated with blocking primer.
Hard, smooth substrates should be sanded to a matt finish and painted with primer.
Cracks, unevenness and holes must be filled.
Paint absorbent and porous substrates with primer.
Untreated, painted and wallpapered substrates should be primed.


Apply on wall using brush, roller or spray gun with after rolling.
Adjust layer thickness to substrate and wall covering.
Apply uniformly wet on wet and finish by brushing/rolling in the same direction.
Allow the adhesive to dry briefly before hanging the wallpaper.
Differences in layer thickness or uneven structure can result in a non-uniform substrate.
Insufficient layer thickness results in the risk of blistering and inadequate adhesion.
Excess layer thickness results in the risk of cracking and visible stains.
Adhesive applied to the front of the wallpaper may cause visible stains.
Cold/heat can affect the viscosity of the material.
Condensation must be prevented during drying/curing
Cold and increased atmospheric humidity extends drying time and full curing.
Increased temperature and low atmospheric humidity reduce drying time and full curing.
Always perform a test treatment for a check and acceptance of adhesion and result.

Uniform and well fastened to substrate.
Does not prevent penetration of knots and water-soluble dyes, water stains and nicotine.
Exercise care in loading the substrate until the adhesive is fully cured.

Be Aware

Ensure good ventilation during and after hanging.

Technical Data

Bonding and Glue
Density (kg/liter)
Weight %
Volume %
Nominal spreading rate (m2/l)
Min. +15°C
Max. humidity 80 % RH.
Do not dilute
Cleaning of Tools etc.

Storage: Cool, frost free and tightly closed

Clean off the paint from tools and wash them with water. Bring remains of fluent paint to the local recycling centre. Minimize your paint waste by pre-estimating how much paint you need. Keep the leftover paint for future use so you can effectively reduce the environmental impact.:


October 2020