Floor Paint Epoxy

Floor Paint Epoxy

Flügger Floor is products for treatment of concrete and wooden floors. The products combine easy application, wearability, washability and finish.

Product Description

Extra wear-resistant, resistant to chemicals Epoxy Floor Paint. Recommended for premises with high functional requirements that are exposed to light traffic, use-related wear, the effects of chemicals and some soiling.
  • Extra abrasion-resistant surface
  • Diffusion-open
  • Resistant to chemicals


Floors in commercial premises, institutions, light industry, shops, clinics, institutional kitchens, stairways and stairwells.


Must be clean, dry, solid and suitable for surface treatment.


Remove cement slurry by machine grinding.
Remove loose material and paint by cleaning and sanding.
Remove dirt, grime, grease, oil, wax and chalking materials by cleaning with Fluren 37.
Remove soap residue using Fluren 33.
Sand hard, shiny surfaces matt.
Repair concrete damage with concrete.
Cracks, irregularities and holes must be spackled with epoxy spackle.
Prime absorbent and porous surfaces with Epoxy Floor Paint diluted with 20 % water.
Best durability is achieved with 2 treatments.
If there has been more than 24 hours between treatments, the surface must be sanded to a matt finish.
Some colours require an extra treatment.


Brush or roller.
Mixing conditions: All of component A (hardener) is mixed with all of component B (base), followed by thorough stirring.
Machine mix at low rpm for 4-5 minutes if the container is larger than 1 L.
Decide your choice of tool/utensil depending on the finish
Apply wet on wet and finish by brushing/rolling in the same direction
Always use the same batch number on contiguous/unbroken surfaces
Differences in surface structure can result in colour deviation
Cold/heat can affect the viscosity of the material
Condensation during drying/curing must not occur.
Cold and increased humidity extends drying time, full curing and recoat interval
Increased temperature and low atmospheric humidity reduce drying time and full curing
Always perform a test treatment for a check and acceptance of adhesion and result


Glossy extra abrasion-resistant surface.
Withstands vigorous cleaning with water, machines and cleaning agents.
Epoxy paint dulls under the effect of sunlight. Lighter nuances yellow over time.
Where the tires of a parked vehicle place a load on the surface, adhesion and peeling may occur unless the painted surface is covered by a protective coating, mats or the like.
Exercise care in loading the surface until the paint is fully cured.
The surface can be used after 10 hours.

Environmental information

Clean off the paint from tools and wash them with water. Bring remains of fluent paint to the local recycling centre. Minimize your paint waste by pre-estimating how much paint you need. Keep the leftover paint for future use so you can effectively reduce the environmental impact.

Storage: Cool, frost free and tightly closed

Protection equipment: Painting: eye protection, gloves. Sanding: respiratory protection.

Technical Data

Epoxy paint
80, Gloss
Density (kg/liter)
Weight %
Volume %
Nominal spreading rate (m2/l)
Workable temperature
Min. +10°C
Max. humidity 80 % RH.
Fully cured at 20c, 60% RF (Days)
Emission cf. ISO 16000-9:2011
10 < µg/m²h after 28 days
Cleaning of Tools etc.

Current TDS Version

styczeń 2021

Replaces TDS Version

wrzesień 2020