Sandplast S Spray Filler

Sandplast S Spray Filler

Flügger Sandplast is a ready-mixed, ready-to-use filler. Used for smoothing out of ceilings and walls. The products have optimised working properties and filling capacity, good sanding characteristics and produce minimum shrinkage.

Product Description

Spray filler for dry rooms. Contains fine-grained, heavy filler paste with good filling capacity. Finish by treating with a wall covering and/or suitable ceiling or wall paint in the desired colour and gloss.
  • Fine spray filler
  • Good filling capacity
  • White

Usage

Filling or structural spraying for smoothing out of plaster, concrete, lightweight concrete and previously painted surfaces.

Substrate

Must be clean, dry, firm and suitable for surface treatment.

Treatment

Remove loose material and paint by cleaning, sanding and dusting.
Remove dirt, grime, grease and chalking materials by cleaning with Fluren 37.
Water-soluble discolouration, nicotine and soot can be cleaned with Fluren 49.
Sand flat hard, slippery surfaces.
Apply the filler paste and smooth out.
Sand the surface and prime it before any additional treatment.
Can be used for structural spraying of ceilings without additional treatment.

Application

Apply using a special spray system and smooth out with a filler knife.
Decide your choice of tools based on the size of the surface.
Apply a sufficient amount and then work and smooth out the filler paste.
Cold/ heat can affect the viscosity of the material.
Condensation during drying/curing must not form.
Cold and increased humidity extends drying time, full curing and recoating interval.
Increased temperature and low atmospheric humidity reduce drying time and full curing.
Risk of shrinkage where the filler paste is not completely cured before additional treatment.
Always perform a test treatment for a check and acceptance of adhesion and result.

Even surface for additional treatment.

Technical Data

Producttype
Plaster & Sealant
Colour
White
Density (kg/liter)
1,7
Weight %
71
Volume %
0
Nominal spreading rate (m2/l)
1
Min. +10°C
Humidity
Max. humidity 80 % RH.
Dry to touch at 20°C, 60% RF (Hours)
2
Recoatable at 20c, 60% RF (Hours)
20
Fully cured at 20c, 60% RF (Days)
28
Emission cf. ISO 16000-9:2011
16 < µg/m²h after 28 days
0,64
2
0,25
10
Cleaning of Tools etc.
Water

Storage: Cool, frost-free, and tightly closed

Clean off the paint from tools and wash them with water. Bring remains of fluent paint to the local recycling centre. Minimize your paint waste by pre-estimating how much paint you need. Keep the leftover paint for future use so you can effectively reduce the environmental impact.:

Version

September 2020